Micro Drip Irrigation

What is the flow rate of the 2-Way Assembly?

.3 GPH per stake

What is the flow rate of the 4-Way Assembly?

.2 GPH per stake

How many drip stakes do I need for a 1 gallon QuickFill?

2 stakes

How many drip stakes do I need for a 2 gallon QuickFill?

2 stakes

How many drip stakes do I need for a 3 gallon Pot?

2 stakes

How many drip stakes do I need for a 5 gallon Pot?

4 stakes

How many drip stakes do I need for a 10 gallon Pot?

6 stakes

How many stakes do I need for a 4” rockwool cube?

1 stake

How many stakes do I need for a 6” rockwool cube?

2 stakes

Which Micro Dripper assemblies are recommended with Rockwool cubes?

2-way parallel Micro Dripper assemblies. (0.3GPH flow rate per stake)

What is the best way to straighten the 16/17mm Double Layer or Micro Drip Tubing?

Step 1. Slightly warm it up by placing it in the sun or grow room. Step 2. Roll the tubing out on your table/floor, adding a piece of tape every 3-4’. Step 3. Attach all the 16/17mm pipe fittings. Step 4. Remove the tape after 24-48 hours and voil

Why are my Micro Drippers not working, flowing or dripping?

Micro Drippers need a minimum of 15 PSI and the drippers will not dispense water unless it is reached. You will want a pump that has 15 PSI or a max head height of 40’. If your pump does not have a PSI rating you can figure it out using the formula below: Max head height x .433 = max PSI i.e. 20’ max head height 20 x .433 = 8.66 psi

What do I use to make a hole in the 16/17mm double layer tubing to connect the emitter?

Our Flora Puncher.

How can I connect the Double Layer Tubing to my PVC pipe?

Can I use the 100 foot ¼” Flora Tubing with this system?

Yes, the ¼” Flora Tubing is compatible with the .5 GPH emitters. This is not common as the Micro Drip Assembly units are the popular method.

Do I need a pressure reducing valve or pressure regulator to work with this system?

It depends on the pump being used. In most cases it is recommended to add an in-line pressure compensating basket or y-filter at the inlet of each zone. You can always place a pressure gauge towards the end of a zone to ensure you are within your desired PSI.

What is the Double Layer Tubing for?

Our 16/17mm double layer tubing serves as a manifold for the Micro Drip System.

Do I need any PVC glue or adhesive with the Micro Dripper System?

No, you will only need PVC glue and primer for your core plumbing such as PVC.

Is there a substitute for the Double Layered tubing?

16 mm poly tubing.

Do you guys make a flush valve?

Yes, (insert link here).

Please, mind that only logged in users can submit questions

Your question:

Your name:

get notification on email when the answer is ready

Your e-mail: