Compression plastic irrigation fittings are commonly used to connect irrigation pipes to valves and sprinklers. However, sometimes it becomes necessary to remove them, either for repair or replacement. In this article, we'll cover how to remove compression plastic irrigation fittings without damaging the pipes or fittings.
Here's a step-by-step guide on how to remove compression plastic irrigation fittings:
-
Turn off the Water: Shut off the water supply to the irrigation system before attempting to remove the compression plastic fitting.
-
Loosen the Nut: Use a wrench or pliers to loosen the compression nut that secures the fitting to the pipe. Turn the nut counterclockwise to loosen it.
-
Slide the Nut and Fitting Off: Once the nut is loose, slide it and the fitting off the pipe.
-
Remove the Insert: If the compression fitting has an insert, use pliers to pull it out of the pipe.
-
Clean the Pipe: After removing the compression fitting, clean the pipe and inspect it for damage. If the pipe is damaged, it may need to be replaced.
-
Replace the Fitting: If the compression fitting needs to be replaced, follow the manufacturer's instructions for installation. Make sure the new fitting is the correct size for the pipe and is compatible with the irrigation system.
In conclusion, removing compression plastic irrigation fittings can be done easily by following the steps above. Remember to turn off the water supply before attempting to remove the fitting and use the appropriate tools to avoid damaging the pipes or fittings. If you encounter any problems, consult with a professional to avoid causing further damage to the irrigation system.
